Sunday, June 2, 2013
Replacing the filter and engine oil Car Audi 100
The sequence of execution: 1.Neobhodimo warm up the engine. 2.Zatem unscrew the drain plug on sex trafficking. Then set the container for collecting oil and unscrew the plug. 3.Dozhdites until all the oil will flow down, pushing capacity if needed. 4.Protrite cover and if necessary change the sealing washer. Wipe the area around the hole and tighten the cap. 5.Pod oily filter set capacity for oil. 6.Pri using tools remove the oily filter. 7.Dalee clean place to install the filter, lubricate oil seal for the filter. Secure it and then tighten by hand. 8.Zaleyte oil and check the dipstick. 9.Zapustite engine and make sure that no leakage around the Pancake filter and plugs the drain. Note: On models where the turbocharger is installed is not recommended to raise the engine speed until the indicator light goes off oil pressure. Check brake pads front brake on the Audi 100 In order to check the brake pads, need to raise the front of the car. Then remove the front wheels. The thickness of the brake pads can be seen through a hole on the front calipers. To define more precisely of wear, they must be removed and cleaned. If the thickness of some stocks fell more than the permissible value, then they need to change on both wheels. Replacing spark plugs in the Audi execution sequence: 1.Neobhodimo unscrew the screws and remove the cover from the valve cover. 2.Dalee mark the high voltage wires and disconnect them from the spark plugs. 3.Protrite area around the spark plug, and slowly at the special tool to remove the candle. 4.Izmerte spark gap spark plug with a special tool or set of probes. 5.Podognite its tip, thereby otreguliruete it. 6.Ustanovite spark plug in place. To facilitate their work, put a short pipe at the candle. This segment will serve as a universal joint and do not give a groove crank. Removing Pancake pan Audi execution sequence: - In the first lift and secure the front of the car - next step is to remove the lower guard engine and then pour the engine oil - Good fix the engine on the lift - Remove the front cover of the gearbox - Next you need skurit lower engine mount nuts - under the front suspension crossmember install the jack, loosen the screw and slightly lower crossmember - Remove the pan bolts - Remove the pan. Installation: Before installing the need to clean the surface of the pan and cylinder block, and then install a new gasket. Setting the tray is carried out in reverse order of removal.
No comments:
Post a Comment